![]() ![]() Native/direct playback of DSF/DSDIFF files (ASIO DSD, DoP v1.1 with both 0x05/0xFA and 0x06/0xF9 markers) Selectable algoritm and noise filters for DSF/DSDIFF PCM playback (11 / 8 options) Playback of DSF/DSDIFF files through any supported audio interface (PCM conversion and DSD rate conversion) Software-based digital volume control for PCM and SDM (DSD) Optional high-frequency expansion for the convolution engine Selectable convolution algorithm (FIR) for equalization, such as digital room correction (2 options), for PCM/DSD content ![]() ![]() Selectable dithering / noise shaping algorithm (9 options) Software upsampling / downsampling with selectable algorithm up to 32-bit 1.536 MHz or down to 8-bit 32 kHz PCM (28 options, most 'apodizing')ĭelta-Sigma modulators for upsampling PCM/DSD content up to 98.304 MHz 1-bit SDM (11 modulators, 30 PCM oversampling options and 2 DSD rate converters) Both Roon and HQPlayer expect to have exclusive access to the device, and they might conflict if you configure both at the same time.HQPlayer 4 Desktop - upsampling multichannel audio player for Windows. This works best if you first press the 'stop' button in HQPlayer, then make the adjustments you want, then proceed in using Roon.If you're using a device in HQPlayer, make sure that the device is disabled in Roon's audio settings. If you attempt to initiate control from another piece of software, Roon will lose control of HQPlayer.HQPlayer filter settings can be adjusted from within HQPlayer. You will want to select the first option of 'time' in HQPlayer for the playback bar to properly progress in Roon.An HQPlayer instance can only be controlled by one external piece of software at a time. HQPlayer has multiple options of displaying the play time, “time”, “remain” and “total remain”. If Roon detects that you've manipulated transport controls from HQPlayer, it will stop the music and release control of HQPlayer. Finally, choose HQPlayer from your **Zones menu**# Notes for Roon/HQPlayer When controlling HQPlayer from Roon, **use the transport controls within Roon**. This is the globe icon on the far right hand side of the HQPlayer toolbar:Mac | | Windows- |- | -| |**Step 2**: In Roon, go to Settings/Setup/HQPlayer and click 'Add HQPlayer'.**Step 3**: **Enter the network address where HQPlayer is running**: - If HQPlayer is **running on the same computer** as your Roon Core, leave the default `localhost` value, then press **Add** - If **HQPlayer is running on your network but on a *different* computer**, enter the local IP address of that computer, then press **Add**.*Note: You can find out your IP address by - just make sure to use your **local IP address**, as opposed to your external/public IP address.* The local address will most commonly look like `10.x.x.x`, or `.x`. *Note: HQPlayer 3.12.0 or higher is required.*# Setting Up Roon And HQPlayer To setup Roon to output to HQPlayer follow these steps:**Step 1**: In order to connect to HQPlayer using any address other than `localhost` or `127.0.0.1`, you must enable the 'Allow control from network' feature in HQPlayer. # HQPlayer Setup-# ] > ] > HQPlayerRoon can stream directly to ], whether both applications are running on the same machine or if they're on different machines on your network. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |